particle board production line

Particleboard Production Process(Brief)

1.Wood shavings preparation Section

Short and long logs of small diameter are fed into long-log flaker by the feeding conveyor, which sliced into qualified shavings at once, then the flakes will be sent to wet flake bin. As for short branches and other materials, what will be sent to feeding belt conveyor of drum chipper. Raw material are whittled to qualified chips by chipper, then wind send these to wood bin as intermediate storage. Wood chips then pass the ring flakers to be qualified wood shavings, and will be sent to the wet flake bin by wind.

2.Drying and sieving section

The flakes discharged from the wet flake bin are conveyed to the rotor dryer through screw conveyor. Qualified flakes are screened in screening machine. Screw conveyor of dryer is equipped with spark detection devices,once alarms, dry materials will be discharged outside the system automatically. Qualified core flakes are stored in core flake bin; oversize flakes will resent to mill to be re-crushed, and transported to surface flake bin.

3.Glue mixing and applying section

This section includes the wax emulsion and hardener solvent’s preparation and transportation, additive storage and glue mixing and spreading system. After scaled, the core and surface flakes are to be effectively and uniformly mixed with qualified glue independently in their glue mixers respectively.

4. Forming and hot-pressing section

The surface and core flakes are sent into classi-forming machine, and forming on the mat conveyor uniformly. After processes of mental remover, pre-press, lengthwise saw, cross saw, accelerate conveyor, scaling conveyor, storing conveyor and loading conveyor, mats are transported to carrier and then to hot press. Rough boards after pressing are pushed to unloader via pallet.

5. Cooling and sizing section

The rough board is conveyed to star-cooler for cooling, then the rough board goes through side trimming saw and become a qualified particle-board, stacked on the hydraulic lift.

6. Sanding section

The storage board are sended into sanding system(include hydraulic lifters, roller conveyors, wide belt sander). Then sanded,checked and stored.

7. PLC system

The main controlling room is set in this particle board production line, through this you can realize operating all machines automatically and manually from wood shavings measured, spreading, shaping, hot press to trimming processes. Besides, set controlling console (box) in the operating scene for each section(except hot press section) to control and monitor each machine’s operation.